A note on Ring Sizes: Most of our rings can be re-sized UP or DOWN about two full ring sizes from those shown on the web. Some inlay style rings cannot be re-sized at all, and certain others should not be. We will do this at $10 per ring, when possible, if you request it when ordering. If you request a ring to be re-sized that should not be done, we will tell you.
If you don't know your ring size follow
these instructions and you will be able to determine
it.
#1 - Cut a strip of paper no wider than 1/4" (or 6 MM).
#2 - Wrap the paper snugly (as you want the ring to fit) around your finger
and mark the paper where it meets.
#3 - Measure the marked length of paper and compare it to the chart below.
You now have your ring size. If you feel uncertain
of your measurement, we suggest a visit to a local jewelry store, or department
store, and ask their jewelry counter personnel to measure it for
you!!
Note: If your knuckle is significantly larger than the base of your finger,
you should measure the knuckle as described above and pick a size
somewhere in between the two.
Ring
Size
|
Paper Length
(in inches) |
Paper Length
(in millimeters) |
4 |
1 13/16 |
45 |
5 |
1 15/16 |
48 |
6 |
2 1/16 |
51 |
7 |
2 2/16 |
53 |
8 |
2 4/16 |
56 |
9 |
2 5/16 |
58 |
10 |
2 7/16 |
61 |
11 |
2 9/16 |
64 |
12 |
2 10/16 |
66 |
13 |
2 12/16 |
69 |
14 |
2 14/16 |
72 |
Bracelet Sizes: Our bracelet sizes are determined by wrapping a flexible tape measure inside the bracelet, completely around and across the "gap". If the reading on the tape measure shows 7", for example, that is the size we assign to it. If a flexible tape measure is wrapped completely around the wrist, in a comfortable fashion, where the bracelet is to be worn, the reading on the tape should indicate the bracelet size. Most bracelets can be opened up maybe a half size, or closed down maybe a half size in order to get a good fit. However, those with inlaid stones, or similar construction, cannot be opened or closed in any amount without damage to the stones!